Warning on TP 3rd party disk drive carrier(s)

[Michael Redmond <redmond@engr.wisc.edu>]

I put a 19mm drive into my TP755CD using a metal carrier from PS-Solutions.
I am now finding that the carrier comes loose from the TP connector because
the wire handle doesn't engage with the "hold down" tabs that are used with
the original TP case. 

I carry my machine around a lot, so I expect it is working loose from
vibration. I have had scan disk errors that I assume can be attributed to
bad connection. This can be very "dangerous". PS-Solutions didn't have an
answer to fix it, though they are willing to have me send it back. For now,
I put a piece of thick tape over the drive case at the connector end to try
to get pressure from the closed keyboard to hold it in place. This isn't a
very good solution in my opinion, but I'll try it for now.

I am not sure if other carriers are any better. If you've tried a different
carrier that utilizes the hold down tabs, I would like to know. I would
switch to that.

Thanks
Mike Redmond